Running the Prevent System
      Back to home
      1. Help Center
      2. Running the Prevent System

      Pre-Session Syncing and iMG Deployment

      Sync Before Use? Before each session, it is essential to connect each Prevent iMG to the Prevent App.

       

      The pre-session syncing process is vital for accurate data collection, as it sets the correct date and time stamp on the device.

      Keep in mind that this timestamp resets when the iMG loses power, making it imperative to perform this step for every session.



      1. Open the Prevent App whilst the iMGs are on-charge. Allow 30-seconds for all iMGs to establish a Bluetooth connection. To verify that each iMG is connected, please refer to the image below:

        App - iMG Connectivity
      2. Once all iMGs are charged and synced pre-session, they are now prepared for data collection. Disconnect the solo charging case from the power source and carefully take out the Prevent iMG. Instruct the athlete to wear the iMG on their teeth throughout the session, as they would during regular use

       

      Note: Once disconnected from the power source, the Prevent iMG is always on and active. For guidance on how to extend this battery life prior to a session, please see the following article: